Search results

  1. snowman22

    LML P0103 (MAF High Frequency)

    Never had this come up before and of course it happens 3 hours from home with the trailer. It sets immediately after start up and also sets again while driving immediately after clearing the code. I cleaned the MAF after limping the truck home and it didn't change a thing. I didn't see any...
  2. snowman22

    Question: Axle Block on 5th Wheel. Good or Bad Idea?

    I recently purchased an older 5th wheel travel trailer and GVRW is 8200lbs It sits way too low and I'm trying to figure out what I can do without welding a subframe for the hangers if possible. In an absolute perfect world it needs 5-6" of lift, but 3ish would be a decent improvement from what I...
  3. snowman22

    LML "Service Exhaust Fluid System" No DTC's after DPF Re-Install

    I couldn't find any useful info on what would cause this so I figured I would put it out there after fixing it. I had to re-install my factory exhaust and after doing so the system started a countdown from 99 miles to reduced to 65mph. The edge CTS didn't show any codes, so I figured I...
  4. snowman22

    LML Cleaning the DPF Filter

    Is there any proven way to clean a DPF filter with water or any chemical solution? I have the exhaust off the truck, completely intact and it was off a long bed, so I can't exactly get right to the face of the DPF easily. It's performance was diminishing (frequent regens) and before it goes...
  5. snowman22

    LML Injector Life

    I haven't been able to anything good on the subject, so what are you guys generally seeing for stock injector life on a tuned LML? I ask because recently mine has started to have a raw diesel smell at idle similar to my LB7 when it needed a set of injectors. It doesn't haze, no white smoke...
  6. snowman22

    LML ABS Causing Strange Bump at Stop Lights

    So this has been a long saga and I’ll try and make it short because I’m out of ideas and need some help. Two weeks after getting my trans built by Mike it started this strange free roll and harsh stop at the last 3-5ft coming to a stop light, but an intermittent issue and varying severity...
  7. snowman22

    Anyone on iRacing?

    I'm going to give it a try and see how it feels. I got a cheap logitech G920 and plan on running it for a while on my 15" Surface book. It's an 8th gen i7 4.2 GHz with 16gb ram and a GTX1060 with 6gb dedicated. I will probably have some heat issues, but I don't want to build a machine if it...
  8. snowman22

    LML Disable StabiliTrak

    I know I have read that you can unplug a wheel speed sensor to disable all traction control, but has anyone put a micro relay on it to disable with a switch? Would that also kill ABS or just traction control?
  9. snowman22

    LML Overhead Control Wire Diagram Needed

    Does anyone have access to the wire diagram for the overhead controls on a sunroof equipped 15.5'? I ordered a Garmin dashcam and need constant and switched power for the install kit and would prefer to stay up there if possible. I can sit there with a meter if I have to, but a diagram would...
  10. snowman22

    LML Floor Mats = Valet Mode

    Not sure where to put this, but figured everyone should get a good laugh from this. Long story short my brother borrowed my truck the other day and called me to tell me how slow it is in comparison to his 6.7. That it doesn't even downshift on the freeway if you floor it, that my trans is...
  11. snowman22

    Exergy CP4 Longevity??

    So I've been looking for information on the Exergy CP4 and can't find too much. I've seen a few people who run them, but does anyone actually know if Exergy did anything to keep it from coming apart in spectacular fashion? I've read too much about issues with a CP3 conversion and honestly...
  12. snowman22

    DHD Brace or Flat CV Angle?

    So I'm having a hard time deciding which to do. I'm on basically a stock size tire, but have the torsion bars cranked a little to help level the truck, but not completely level. It's cranked enough to change the CV angle, but not enough where I think I must drop the t-case. My LB7 was 2wd so...
  13. snowman22

    Best Tow Story Yet

    Not sure how many, if any, of you have seen this, but....I couldn't leave this alone. I've most definitely seen a fair share of idiots, and even done a few dumb things while towing, but this just might be taking it to a new galaxy. It's a uhaul truck towing a trailblazer which is towing...
  14. snowman22

    Banks Diff Cover Video

    Have any of you guys watched the videos Banks is doing on aftermarket differential covers? I've never been a fan of them, just like deep trans pans, but for a few different reasons. It seems pretty interesting especially since he seems to be trying to prove the stock one is the best...
  15. snowman22

    LML 13.2v Charging Too Low?

    I've had my LML for probably 15k miles now and it's always been charging between 13.2-13.8v. I changed the batteries a few months ago and the voltage stayed the same. It seems lower than it should be and I don't want to end up stranded one day because I continue to avoid it. The headlights...
  16. snowman22

    LML Cracked Front Diff..Fixable?

    Today when I was under the truck getting ready to install new tie rods, U joints, and other things to make a 4wd launch possible, I found a little surprise waiting for me....I hate finding broken things when I don't have a good story to go with it! The crack is weeping oil, but not dropping...
  17. snowman22

    LML Tie Rods w/ Braces or Not?

    So,I hate to start a new thread on something that has been discussed a hundred times.. But after reading as much as I can, I still can't make up my mind. I'm trying to figure out if just PPE or equivalent tie rods will be sufficient or if I should also install the idler/pitman arm braces as...