Recent content by Eh-ef-kay

  1. E

    Having an issue after swapping in used engine.

    Thought I would throw an update. I swapped out the front cover from my old motor and have oil pressure but now for some reason I’m not making enough fuel rail pressure to run. If I crack open the bleeder screw by the filter it’s got a lot of flow right there but at the injectors themselves it...
  2. E

    Having an issue after swapping in used engine.

    OK so the front cover off spun the bolt on the oil pump with an air gun oil pressure rose up to 40 without any issues. So I’m going to gather that it’s losing pressure somewhere else
  3. E

    Having an issue after swapping in used engine.

    I mean it’s bolted down and the gears in place. Next step was to try to turn the pump by hand and see if anything comes up out of it.
  4. E

    Having an issue after swapping in used engine.

    Yeah this happened in December I bought the motor towards the end of December it took him two months to even get started on it it sat for that long motor and all. I have tried another filter already. Somebody was already in the bottom of the motor there were signs that somebody’s ziz wheeled it...
  5. E

    Having an issue after swapping in used engine.

    So I posted a few different places but figured since this one is more directed at these motors maybe somebody here will have some knowledge. Long story short I have a 2007.5 LMM fully deleted. The motor had some piston issues so I got a motor from an ambulance van lmm with under 100,000...
See more
Top Bottom