Recent content by Chucky797

  1. C

    Driver/passenger seat issues

    Thanks for all the help, i was able to find it. I traced the wire under the seat and found that it was corroded/broken under the door sill. Spliced in a new piece of wire and soldered/heat shrink and the seat moves again. Also, the heated seat works again too so that is a huge plus.
  2. C

    Driver/passenger seat issues

    I have looked at the diagram and can't see any that talk about the seat adjustment. All the wiring diagrams i see say there should be a 30A fuse, but don't know what one it is supposed to be.
  3. C

    Driver/passenger seat issues

    I have been trying to figure out the issue with my driver/passenger seat for awhile now. The driver seat won't move and the heated seat on the driver/passenger side doesn't work. When i check the orange wire under the driver seat there is no power at the connector. I am guessing that is...
  4. C

    Blower Resistor

    My blower resistor has gone bad (fan won't change speeds, remains on even when truck and AC unit turns off) so i am looking at getting a new one. Each time i look for the part it seems the connectors are different, did GM make a new one? If so, are there any directions on how it is supposed to...
  5. C

    *Help* Truck Wont Start

    Voltage drop to the starter was only .2. I replaced it and it now starts again.
  6. C

    *Help* Truck Wont Start

    Got a new update, went and put a multimeter on the batteries while trying to crank. They hold over 12v. I then did a voltage drop from the positive lead of the battery to the starter and only showed a .1. I am going to assume my starter went bad.
  7. C

    *Help* Truck Wont Start

    Okay, so i am reaching out for some help. I went to get in the truck yesterday and it all of a sudden wouldn't start. The voltage gauge on the truck read about 11ish volts, but when i go to turn it over all it does it click. So i get another vehicle and hook it up to the truck to jump it...
  8. C

    Electrical issue

    So I have recently realized that the heated seat, horn, and driver seat power seat do not work. Does anyone know if there is a fuse that controls all of these features? If not, is there some other aspect of the truck that controls most of these. They seem to have all went out at the same...
  9. C

    SoCal Machine Work

    Cool, I just wanted to make sure there wasn’t some small shop that I didn’t find. I will have to call him Monday.
  10. C

    SoCal Machine Work

    Hey, just moved to SoCal and i have a block that needs to get some machine work. I hope to drop it off soon so they can start some work. What i need is to have the cylinders honed, mains honed, new cam bearings, freeze plugs, and the block checked out. I would prefer if the shop already had a...
  11. C

    LBZ: found the source of my electrical problems

    what was the issue it was causing and where did you find the problem?
  12. C

    LBZ: Exterior lights

    Well it looks like I am back facing the headlight issue. My high beams work and now my low beams do not. While I was driving home from work I hit a bump and the low beams went out. I got a multimeter out and found out this information. Does it look right to you. It was all tested at the...
  13. C

    Black friday

    Where do we enter the coupon code for dhd?
  14. C

    My Lmm build

    I just bought a new lml crank. I will buy a new flywheel, and balancer then have it all balanced together. I got it for 728$ shipped to my door. I will also have it keyed while at the machine shop.
  15. C

    Interchangeable parts

    does anyone know if a LBZ reluctor wheel will bolt up to a lml crankshaft oil drive? I know on the lb7 and lly they are three bolts where the LBZ is a four bolt set up. Unless someone has a gear and reluctor ring for an LBZ sitting around they want to get rid of?