Search results

  1. M

    Blown Turbo?

    The last time I towed with my LML I blew the hotside intercooler pipe off the intercooler. When re-installing it I noticed a small pool of oil in the compressor outlet of the valley charger. Immediately I figured the turbo was shot so I acquired a new one to replace it. Before I purchased the...
  2. M

    Running Edge Starter Cable Through the Fire Wall

    What is the best option for running the edge starter cable through the fire wall on a GMT 900 truck? The smaller of the 2 ends still requires a decent sized hole to pass through. Secondly does anyone know if a typical pressure sending unit will work on Airdog where the low pressure light port...
  3. M

    Mega fuse

    Yesterday moring when I went to use the factory remote start the main mega fuse blew. I replaced it and my truck started no problem with the key. Obviously I have a short but don't know where to start looking.
  4. M

    Turbo oil drain

    I switched my LML rear cover to a LBZ one to do away with the coolant port that was leaking. It had the fleece plug in it as I routed the the heater core to the thermostat housing. In order to do the LBZ rear cover I thought allI needed was a drain line from an earlier turbo as the stud spacing...
  5. M

    Drive pressure gauge

    I ordered a drive pressure guage and was planning on installing in the drivers side manifold since I have a pyro in the passenger side already. After looking at the drivers side manifold a little more closely I don't see and great places to drill and tap it. Does anyone have a picture of there...
  6. M

    LML front drive shaft

    Is there anything special to removing the front drive shaft? I thought it was just a slip yoke but it does not seem to want to slide out.
  7. M

    Hot shot secret additives

    Has anyone here used any of their products in their duramax's? I just come across a post on facebook about these additives the other day.
  8. M

    Torque Converter Selection

    I will be building my trans shortly and I'm wondering which converter will best suit my needs. No drag racing for me. Mostly a street tuck and tow rig. Mods are listed in my sig.
  9. M

    Installing boost gauge on LML

    Can someone tell me how to remove the plastic coldside pipe on the LML where it connects to the butterfly valve. I would like to remove it to drill and tap for my mechanical boost gauge. I attached a pic of what im talking about.
  10. M

    Edge CTS dash mount

    Does anyone know if the edge CTS dash mount will fit on a 07 up interior with a dual gauge pillar. I looks like it would be pretty tight if it does work. I just think it would make for a cleaner look rather than buying a triple gauge pod and CTS pod adapter.
  11. M

    4x4 drive issues

    Ive been trying to diagnose a 4x4 problem for sometime now. My truck likes to but itself self into 4Lo all the time all on its on but does not put any power to the front wheels. It definitely gears down though because its sifts very rough. I ceased my front diff from it always shifting into 4x4...
  12. M

    LB7: Won't Stayed Primed

    MY LB7 has been lossing prime lately and now it wont even stauy running if i can get i primed good enouh to start. I know that this tells me i have a small leak in my fuel system some where. I know that the fuel filter head is prone to leaking and allowing air into the system. My question is...