Duramax Diesels Forum Truck of the Week


Go Back   Duramax Diesels Forum > Search Forums

Showing results 1 to 25 of 500
Search took 0.02 seconds.
Search: Posts Made By: chevyburnout1
Forum: Mike L's Trans Talk 05-03-2018, 11:10 AM
Replies: 125
Views: 11,382
Posted By chevyburnout1
I opted for the Tow\Haul disable as well....

I opted for the Tow\Haul disable as well. Definitely easy enough but I'm excited to hear a tapshift is in the works. The tune in my truck is a temporary tune to keep smoke down as we found out I had...
Forum: Mike L's Trans Talk 05-03-2018, 09:08 AM
Replies: 125
Views: 11,382
Posted By chevyburnout1
Have about 700 miles on my 6 speed conversion and...

Have about 700 miles on my 6 speed conversion and wish I did it sooner! Wasn't looking for any mpg gains, just wanted to get the interstate cruising rpms down. It's not like the wife's 8 speed half...
Forum: Turbo Talk 04-06-2017, 10:15 PM
Replies: 11
Views: 1,412
Posted By chevyburnout1
The exhaust side shouldn't be the restriction as...

The exhaust side shouldn't be the restriction as once the small charger gets up to its operating speed the external gate pops open and directs the rest of the drive to the large charger. However if I...
Forum: Turbo Talk 04-02-2017, 06:43 PM
Replies: 11
Views: 1,412
Posted By chevyburnout1
That 68 may be too large as I can get a good 1:1...

That 68 may be too large as I can get a good 1:1 up to around 32psi, with the large charger barely moving the gauge. From there up the drive starts increasing drastically. Who did the 68 upgrade? Is...
Forum: Turbo Talk 03-27-2017, 09:45 AM
Replies: 11
Views: 1,412
Posted By chevyburnout1
What exhaust housing? Gated? That seems to be...

What exhaust housing? Gated? That seems to be where mine runs with the .89 housing and the gate cinched down. Granted this is in my mismatched compound setup so sorta apples to oranges. There is a...
Forum: Smoke Signals 03-09-2017, 08:58 PM
Replies: 22
Views: 3,089
Posted By chevyburnout1
I'm trying I'm trying! Haha. Spun the impeller on...

I'm trying I'm trying! Haha. Spun the impeller on the truck's water pump a few weeks ago. Had to get that taken care of and make sure it's half way reliable again. Boss man is cleaning out the shops...
Forum: Smoke Signals 03-05-2017, 09:08 PM
Replies: 22
Views: 3,089
Posted By chevyburnout1
PM sent! Surprising what hidden potential these...

PM sent! Surprising what hidden potential these old cruisers had in them.
Forum: LB7 03-05-2017, 09:05 PM
Replies: 15
Views: 1,052
Posted By chevyburnout1
And any locating dowel pins! Amazing how easy...

And any locating dowel pins! Amazing how easy those disappear.
Forum: Smoke Signals 03-04-2017, 04:41 PM
Replies: 22
Views: 3,089
Posted By chevyburnout1
Three month update! Not a lot of physical...

Three month update! Not a lot of physical progress and no baby yet! :roflmao: However did have a major breakthrough in regards to tuning! It's a good thing because any of my mechanical "boost...
Forum: L5P 02-26-2017, 10:51 PM
Replies: 64
Views: 15,428
Posted By chevyburnout1
I'm truthfully surprised with what all is going...

I'm truthfully surprised with what all is going on in that cylinder that GM hasn't implement cylinder pressure sensors like in the Volkswagen TDI's. I never realized this was a factory thing until I...
Forum: Duramax Engine Building 02-26-2017, 10:28 PM
Replies: 10
Views: 1,794
Posted By chevyburnout1
Haha oh man almost forgot about that. I...

Haha oh man almost forgot about that.

I love pulling cabs to do major repairs, but I have a lot under my belt. You could get away with the twins and studs easily without cab R&R. Biggest tip I...
Forum: Appearance & Detailing 02-08-2017, 10:20 PM
Replies: 23
Views: 2,632
Posted By chevyburnout1
Last one I had apart was a peltier setup with a...

Last one I had apart was a peltier setup with a fan that forces the cool air through the seat, and the hot air out the back/bottom of the seat. But it still utilized old school heating elements for...
Forum: Duramax Hard Parts 01-31-2017, 08:37 PM
Replies: 1,223
Views: 191,985
Posted By chevyburnout1
I can vouch for the noise change as well. Changed...

I can vouch for the noise change as well. Changed to fingers oval bowls and a 6480af cam with this last build. The noise difference was pretty moderate. Has messed with me a lot as I'm overly...
Forum: Duramax Tuning, Logging, and Gauges 12-12-2016, 09:01 PM
Replies: 25
Views: 4,239
Posted By chevyburnout1
Did they send you pictures? I'm not trying to bad...

Did they send you pictures? I'm not trying to bad mouth anyone, would just be curious if they did and what the pictures looked like. I asked where the metal would be coming from and how to stop it...
Forum: Duramax Tuning, Logging, and Gauges 12-06-2016, 12:00 PM
Replies: 25
Views: 4,239
Posted By chevyburnout1
Stopped at a gas station yesterday. Upon restart...

Stopped at a gas station yesterday. Upon restart it knocked like there was excessive fuel sitting in the cylinder. Since then it's been rolling diesel smoke at idle. Looks like we have a consensus....
Forum: LML 12-01-2016, 07:26 PM
Replies: 2
Views: 1,236
Posted By chevyburnout1
I've had the same concern after my two engine...

I've had the same concern after my two engine builds. Sometimes it's fast, other times it's super delayed, and sometimes it doesn't move and sets an oil pressure circuit code.
Forum: Appearance & Detailing 12-01-2016, 07:23 PM
Replies: 40
Views: 5,844
Posted By chevyburnout1
Mine are still holding up!! Still regret not...

Mine are still holding up!! Still regret not buying them sooner!
Forum: LB7 11-26-2016, 10:52 AM
Replies: 144
Views: 32,922
Posted By chevyburnout1
Sorry just realized I'm starting to veer...

Sorry just realized I'm starting to veer off-topic. Don't want to lose this thread.
Forum: LB7 11-26-2016, 10:50 AM
Replies: 144
Views: 32,922
Posted By chevyburnout1
I'm not trying to badmouth any companies, just...

I'm not trying to badmouth any companies, just trying to get my truck to stop smoking. I understand these LB7 injectors are brittle, but the transaction just didn't make me feel the greatest. Exergy...
Forum: Gallery 11-23-2016, 06:22 PM
Replies: 33
Views: 2,921
Posted By chevyburnout1
Congrats James! Always a great feeling! The truck...

Congrats James! Always a great feeling! The truck looks amazing!
Forum: LB7 11-22-2016, 10:01 PM
Replies: 144
Views: 32,922
Posted By chevyburnout1
Found out I wasn't the only one after posting in...

Found out I wasn't the only one after posting in one of my threads.. Quite a bummer to hear. Lets hope for continuous good news about these nozzles by the time spring shows up!
Forum: LB7 11-20-2016, 08:53 PM
Replies: 144
Views: 32,922
Posted By chevyburnout1
Add me to the list of Exergy customers being told...

Add me to the list of Exergy customers being told their injectors were worn out and had metal contamination, with only 20,000 miles.

Subscribed for more long-term info.
Forum: Duramax Tuning, Logging, and Gauges 11-20-2016, 08:32 PM
Replies: 25
Views: 4,239
Posted By chevyburnout1
I'm truthfully not a fan of the injectors right...

I'm truthfully not a fan of the injectors right now, especially with only 20,000 miles on a completely new $3400 set from Exergy. Factory fuel filters changed more than they should, only name brand...
Forum: Duramax Tuning, Logging, and Gauges 11-15-2016, 08:55 PM
Replies: 25
Views: 4,239
Posted By chevyburnout1
My biggest concern was that Exergy had them all...

My biggest concern was that Exergy had them all apart, then threw them back together when I declined new ones. Said they found metal debris, but they were still flowing correctly. Then it was...
Forum: Duramax Tuning, Logging, and Gauges 11-15-2016, 03:51 PM
Replies: 25
Views: 4,239
Posted By chevyburnout1
OH, one thing that I just thought of as well....

OH, one thing that I just thought of as well. Since the build my ECM does not store the VIN or serial numbers anymore when I'm programming it. I have to use the old V7 programming procedure for it to...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -7. The time now is 03:18 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
vB.Sponsors