Recent content by ncdmax03

  1. N

    No crank

    With relay installed got power on 85 86 87
  2. N

    No crank

    Have done swapped them a few different times an no change I hope to get back in shop here shortly an stick fuse buddy in an Check again havent made it back in shop for working on other junk
  3. N

    No crank

    Relay is removed
  4. N

    No crank

    Got 12v power on pin 85 an 87 at edu relay a n thats it
  5. N

    No crank

    I've tested the wires an had the whole fuse block disconnected an checked for corrosion an broken wires the wires from the black plug to the ecm is good now yes I have no power on either side of the fuse with key on everything else does iam going to check the relay again tonight when I get back...
  6. N

    No crank

    If I jump power to ecm wire the ecm will wakeup an truck will run
  7. N

    No crank

  8. N

    No crank

    Fuse block is tore apart an there is no chewed wires or broken wires to ecm your check the #1 #2 fuse in diagram there is no power on them now have 12v coming in power supply to fuse block (the whole fuse block) but don't have any power at the terminals for these 2 fuse that make more sense
  9. N

    No crank

  10. N

    No crank

    Here's a diagram of it an its fuse 1 an 2
  11. N

    No crank

  12. N

    No crank

    That was a pic of a fuse box I had on my phone to use to show which fuses the one in it has been cleaned will try check again tomorrow when I get back in the shop
  13. N

    No crank

  14. N

    No crank

    So in that case if I got 12v in all other fuses an just 3v on the 2 circled I would have a bad fuse box
  15. N

    No crank

    Ok so does the fuse block have only one power supply to it cause i have 12v in fuse block but none at the ecm fuse
See more
Top Bottom