Recent content by BearsFan42

  1. B

    06 LBZ Slipping Out of Gear

    Got back at it today, and the driver side axel is broke. Got so tunnel visioned and set on the transfer case I didn’t pay attention and check everything else. DAVe3283 suggested back at the end of Nov.and I didn’t do it. My fault for being stubborn
  2. B

    06 LBZ Slipping Out of Gear

    Again thank you for all the advice and suggestions. I did make a video while testing, but I cant get it to load here. Pinion, Ring, Carrier, both spiders all spin when turning the drive shaft by hand. The driver side axel gear spins as well, the passenger side stays stationary. Thinking...
  3. B

    06 LBZ Slipping Out of Gear

    Between the holidays, rain, and flu running thru the household I finally had a chance to get back under my truck today. Wanted to thank everyone for the advice. Below is what i found. Don't have a Tech2 yet. I did put in reverse in 2hi and the driveshaft spun. Put it in neutral it slowed...
  4. B

    06 LBZ Slipping Out of Gear

    Haven't tried that yet. Kinda figured since everything works in 4hi and 4lo, it wouldnt be in the diff, but its worth a look, even for just the fluid change. When I fired it up after putting in the new Tcase, I did notice a couple new things i had not noticed before, when I fired it up after...
  5. B

    06 LBZ Slipping Out of Gear

    As an update, went ahead and put in a rebuilt transfer case. Didn't solve the problem. Thinking it might be the TCM, since the tranny runs fine in 4hi and low. Any thoughts? A few tips on changing the xfr case. There's a bunch of Youtube videos on how to. Definitely get the 15mm stubby box...
  6. B

    06 LBZ Slipping Out of Gear

    Wanted to see if I'm headed in the right direction. My son and I were headed out of town, going about 45 in light traffic when the truck popped out of gear. RPM's shot up and so did the speedometer. While trying to get off freeway, it would pop back in gear then back out. No trouble lights on...
See more
Top Bottom