LBZ: LBZ CP3 Removal Help [Archive] - Duramax Diesels Forum

PDA

View Full Version : LBZ: LBZ CP3 Removal Help


AZBio
09-17-2011, 04:04 PM
Does the Y-bridge have to come out to remove the cp3?

MD-Dmax
09-17-2011, 04:06 PM
Yes it is the easiest way

AZBio
09-17-2011, 04:09 PM
Damn. It doesn't look too easy to get it out.:mad:

AZBio
09-17-2011, 04:11 PM
Yes it is the easiest way

How do you get to the lower rear bolts without removing the turbo?

MD-Dmax
09-17-2011, 05:02 PM
A small ratchet wrench or a swivel socket and a extension. You don't have to take the bottom bolts all the way out either the y bridge has slots on the bottom side loosen them up a little and pull it out

emiller3
09-17-2011, 05:05 PM
Swivel socket 1/4" drive works

PAT
09-17-2011, 06:18 PM
X's 2 on the swivel and extension. Be carefull pulling the socket/swivel out though. I lost my socket in the valley when I pulled the tool out lol. I found it a while later when I pulled tue stock turbo.

rgullett83
09-17-2011, 07:05 PM
If you have torxbits for a 1/4" drive, you can take the lift pump off of the back of the cp3 to get it out, least ways thats how I do it.:thumb:

jraymer
09-17-2011, 07:15 PM
If you have torxbits for a 1/4" drive, you can take the lift pump off of the back of the cp3 to get it out, least ways thats how I do it.:thumb:

x2

AZBio
09-17-2011, 08:34 PM
Thanks guys.:thumb: Went the y-bridge route. Just trying to get it all buttoned up again.