CNC Machined LB7 Mouthpieces in stock [Archive] - Duramax Diesels Forum

PDA

View Full Version : CNC Machined LB7 Mouthpieces in stock


Brayden
02-12-2010, 11:18 PM
We've had these for a couple years, but here's a picture of one that was freshly cut on the CNC.

It features a smooth taper from the bore out to over 3.150" .

They are good for about 10hp depending on your setup.

01 d-maxx
02-14-2010, 04:32 PM
what are they goin for?

ynotracing2221
02-14-2010, 06:26 PM
what are they goin for?

X2

Brayden
02-14-2010, 07:58 PM
75.00 exchange

Brayden
02-14-2010, 07:59 PM
They're smoothed through the entire bore also.

motoking_1990
06-23-2011, 10:58 PM
I found a hair pin hole in mine today it looks like it is in the weld! I live in terre haute, IN also wondering if you could take a look at the data log on my efi live and see what comes up how much do you charge?

paint94979
06-23-2011, 11:35 PM
A leak pre turbo is not a "boost leak". It is just under vacuum it will not effect boost numbers FYI

JoshH
06-24-2011, 07:15 AM
Maybe I'm not understanding what is done here, but I thought this was a stock mouthpiece that has been opened up with a CNC machine. I didn't think there were any welds on it.

motoking_1990
06-24-2011, 11:40 AM
I didn't think it was a boost that's why I haven't fixed it. Prolly helps if anything lol and my mouthpiece is welded all the way around where it bolts to the Turbo.

paul06d-max
07-06-2011, 08:18 PM
Maybe I'm not understanding what is done here, but I thought this was a stock mouthpiece that has been opened up with a CNC machine. I didn't think there were any welds on it.


correct...

liftedon37s
07-11-2011, 07:58 PM
How do I order one of these, maybe I missed it online.